9 replies to this topic

[surachit]

[surachit]

picture

Attached Files

•  loop1cd1a.png   621.68KB   0 downloads
•  loop1cd1.png   613.58KB   0 downloads
•  loop1cd1a1.png   611.35KB   0 downloads
•  loop1cd1a1a.png   488.21KB   0 downloads
•  loop1cd1a1a1a1.png   503.87KB   0 downloads

[surachit]

vhf manatic twin loop    Neither the usual coupling loop or gamma match satisfied me, then the idea occurred of combining the two: it worked, and I call it Combimatch («fig). However this loads the antenna unsymmetrical so I was looking for a more symmetric system. It turns out that a delta match was the answer whereby one part is not connected to the feeder line but loads the loop similar as the other half with the connected coax cable. This feeding system, I call it "quasi delta match", perform as the combimatch but loads the loops more symmetrical.

 CONSTRUCTION

The double-loop (15.5 cm diameter) was shaped from a 1 m length of 3 mm diameter brass welding rod. Using thicker copper tubing may increase the efficiency. A can with an approximate diameter of 12 cm makes a good bending jig. The loop was closed at the crossover by soldering the rod ends into a 2 cm long tube with an inner diameter of 3 mm.

The tuning capacitor is a 10 pF ceramic piston trimmer or mica stamp trimmer which were adequate at a power of 10 W. For outdoor use, some kind of weatherproof enclosure for the trimmer will be required.

One antenna is mounted on a short length of angle profile, which also carries a BNC socket. The assembly is then cemented at the feed point onto a magnetic mount for mobile use.  In another version the loop is soldered onto a BNC plug for direct installation on a handheld transceiver. 

The Combi-match is also made of brass rod, but only after trial with one made of soft copper wire. It turns out that the precise attachment for a point with best SWR depends on the way the BNC connector is mounted.

Generally one emphasises that the capacitor must be a high RF voltage type, but little attention is given on the large flow of RF current which can run. That appeared already with a power of 10 W, because some ceramic trimmers became considerably warm and that changes the capacitance. After polishing the brass that phenomenon was much less, a proof of large VHF current on surface of the rod. For use outside the capacitor should be protected with a housing l against protect against influences of weather.

TUNING AND TESTING

[surachit]

https://pa0fri.home....gloop/magn8.htm

Attached Files

•  lo2.gif   20.42KB   0 downloads
•  loop_antenna-1.png   35.12KB   0 downloads
•  loopf1.jpg   47.87KB   0 downloads
•  loopf3.jpg   28.23KB   0 downloads
•  145loop1a.png   1.6MB   0 downloads
•  145loop1a1.png   1.75MB   0 downloads
•  145loop1a1a.png   899.92KB   0 downloads
•  145loop1a1a1.png   1.08MB   0 downloads
•  145loop5.jpg   28.16KB   0 downloads

[surachit]

https://www.qsl.net/...c/magloops.html

Attached Files

•  loop 10-mtr-magnetic-loop (1).jpg   247.65KB   0 downloads
•  MagneticLoop.jpg   46.73KB   0 downloads

[surachit]

[surachit]

[surachit]

http://f4eoh.free.fr..._au_2m_2746.htm

Attached Files

•  loop500w1.jpg   338.43KB   0 downloads
•  loop500w antenne_boucle_magnetique_500w____3_.jpg   151.36KB   0 downloads
•  loop500w3.png   315.02KB   0 downloads
•  loop 500w antenne_loop_magnetique_a_gain__2_.jpg   433.4KB   0 downloads

[surachit]

https://www.nonstops...nna_magloop.htm

Attached Files

•  27loop1.png   552.12KB   0 downloads
•  27loop1a.png   477.6KB   0 downloads
•  27loop1a1a.png   551.77KB   0 downloads
•  27loop1a1a1.png   381.11KB   0 downloads
•  27loop1a1a1a.png   152.43KB   0 downloads
•  27loop1a1a1b.png   170.15KB   0 downloads
•  27loop1a1a1c.png   165.96KB   0 downloads
•  27loop1a1a1d.png   200.72KB   0 downloads
•  27loop1a1a1e.png   397.4KB   0 downloads
•  27loop1a1a1f.png   634.83KB   0 downloads
•  27loop1a1a1g.png   100.22KB   0 downloads
•  27loop1a1a1h.png   168.72KB   0 downloads
•  27loop1a1a1i.png   228.93KB   0 downloads
•  27loop1a1a1j.png   463.29KB   0 downloads

[surachit]

https://www.nonstops...htm#top-of-page

Attached Files

•  antenna-magloop-slinky-hi-volt.jpg   49.95KB   0 downloads
•  2loop1e1a1a1.png   91.71KB   0 downloads
•  2loop1e1a1a1a.png   424.45KB   0 downloads
•  antenna-80m-vert-nite.jpg   50.22KB   0 downloads